Parts replacement, accessories, installs
1. Shift into the second smallest rear cog. It will make removing and reinstalling the rear wheel easier. 2. Remove the battery. Hold down the power button on the handlebar for 5 seconds or until the display flashes. This is necessary to drain the
Front fender hardware. Rear fender hardware. Use the strut length adjusters to center the fender to the tire. Along with evening the gap. The shorter length fender strut goes o
For a seamless plug and play repair, it's important to ensure we match your current torque sensor with its new replacement. The best way to do this is to find your torque sensor's serial number and to ensure you select the correct one when checking o
Tools needed:. ⦁ 3mm Hex Key. ⦁ 4mm Hex Key. ⦁ 5mm Hex Key. ⦁ Phillips Head Screwdriver. ⦁ 8mm Wrench. *Instructions are shown when the rear wheel is removed. Make sure you remember the axle spacing, if not the torque sensor will not w
Tools:. 5mm/6mm Allen Hex Key, Mallet, Bottom Bracket Remover, Phillips Head Screwdriver, Cutter, Centre Punch, Drill, 5/64 and 3/16 Drill Bit, Cutter, Cutter, 8mm Wrench and Cable ties. Remove left crank with 5 or 6 mm Hex Key. Remove crank cap with
*Be sure to remove the battery and drain the residual power from your bike before doing this repair. In order to drain the residual power from the bike, hold down on the power button (with the battery removed) until the display screen flashes. ⦁ A
How to inspect the wiring harness for damage. Covers motor extension cable, cockpit extension cable, and torque sensor cable — common failure points.
1. Remove battery. Hold down the power button on the display pad for 5 seconds to drain remaining current from the system. 2. Remove the controller and disconnect the motor wire. 3. Flip the bike over on it’s handlebar and saddle -make sure to p
