2016-2019 Rook, Colt, Shred, Boar support
If your pedal assist is erratic or not working at all, your motor inhibitors could be preventing the system from running smoothly. If your throttle works fine, then these steps are sure to help.First, identify the motor inhibitors (orange circle).Use
This video covers the basic steps. https://www.youtube.com/watch?v=KviaJ_Cqt6I 1. Install the non drive side cup until it's fully tight. Set the inner bearing flush with the end of the cup. You’ll tighten that up last. Add some grease to the bearing
Your pedal assist may be intermittent after changing a flat. The reasoning behind this is that there is a specific washer layout that you need to have on your rear axle in order for the torque sensor to output the correct signal to the controller and
